How to Use a Stump Grinder

A stump grinder may be enormous and a little menacing to look with its serrated rotating disc, but it’s not tough to use. The teeth or the rotating disc of the machine is accountable for grinding stumps. Most types of stump grinders have teeth attached to a hydraulic lever and may be moved up, down and from side to side. If you looking a professional arborist in Melbourne you can contact Jim’s Trees and Stump Removal. Below is the process regarding how it is possible to safety and effectively use a stump grinder.

Step 1 — Trim the Tree Stump
Before anything else, you need to trim the tree stump near the ground. If you’re able to chop off the majority of the stump so that the remaining component is already at ground level, so much the better. Reducing the stump will reduce the amount of work for your stump grinder.

Step 2 — Clear the Area Close to the Sump
You want to remove large debris and rocks close to the stump to avoid damaging your grinder. Your grinder is intended to eat tree stumps, not rocks or other hard objects.


Step 3 – Bare the Roots

If you would like to clean your lawn, you need to remove the surface roots of your tree together with the stump. The surface roots of the tree may run away several feet away from the back so before you begin chopping off at the drunk, then locate all the surface roots. Grind these roots along with the stump.

Step 4 — Gear Up
You need to put in your safety equipment before you begin employing the stump grinder.

Step 5 — Start Grinding
Position the wheel of this grinder straight above the stump and turn the electricity on. Most types of grinders make deafening noises so make certain that you wear your ear plugs. After turning the power on, lower the wheel of this grinder before it touches the stump and then let the machine eat the stump. You may use the level on the machine to transfer the wheel from side to side to demolish all the remaining portions of this stump. Let the machine settle in the stump and create a hole about ten inches deep. Make sure you keep your feet out of the way as you let your grinder dig to the stump.

When grinding hardwood, never drive your machine into the stump. Instead, allow the blades of this machine skim through the surface of the stump and feed on it. Yes, this process might take a while to finish, but this will help prevent harm to your grinder.

After grinding the stump, you may begin grinding the exposed roots of this tree. Methodically grind the exposed roots from the stump to the place where they vanish in the soil.

Step 6 — Remove the Wood Chips
After squeezing the stump and the exposed roots, gather the wood chips and set it to a compost pile and let it rot. Decaying wood is a good supply of nitrogen for the soil.

Leave a Reply

Your email address will not be published. Required fields are marked *